1. PLASTIC ADHESIVE

Inc VAT

Solvent-free two-component adhesive

• Quick to harden

• Wide range of applications

• High tensile strength values

• Excellent chemical resistance

• Can be sanded when fully hardened

• High level of transparency

• Silicone-free and solvent-fr

SKU: 08935003 Category: Adhesives

Description

Specification

PLASTIC ADHESIVE REPLAST® EASY FAST

For REPLAST^® Easy plastic repair system

An adhesive for virtually every type of plastic

No need for inconvenient use of different types of adhesive
Can be used for repairs and structural bonding

Special positive mixer

Optimum mixing with minimum volumes
Low adhesive loss (waste)
Quick to harden
Further work, such as sanding, is possible within an extremely short period of time
Excellent chemical resistance
Resistant to a wide range of liquids, such as petrol, many lubricating oils and ethyl acetate

Solvent-free

Application area

Cars
Spoilers,
Radiator grills
Panel clips
Bumpers
Brackets on headlights and radiators etc
HGVs and buses
Aprons
Bumpers
Air intake pipes
Wheel arches etc.
Motorcycles
All panelling

Instructions

The substrate must be capable of bearing loads and must be clean, dry and free from grease and rust. Old adhesive residues must also be removed. To do so, clean the surface with the plastic cleaner and apply the primer. The flash-off time must be observed. Discard some adhesive before screwing on the mixer nozzle. The first 2 cm of adhesive from the mixer nozzle should also not be used. When applying the adhesive, the mixer should remain in the adhesive to prevent bubbles forming. Observe the work instructions.

Technical Information

Contents	50 ml
Chemical basis	Two-component polyurethane
Processing time	1.5 min
Colour	Black
Density	1.225 g/cm³
Min. initial strength	10 min
Min./max. processing temperature	15 to 25 °C
Min./max. temperature resistance	-30 to +100 °C
Silicone-free	Yes

Notice

There may be adhesion problems in individual cases due to the coatings and release agents used in some cases in the plastic production process. Not suitable for PE (polyethylene), PP (polypropylene) or PTFE (polytetrafluor ethylene) plastics. Check material compatibility on an invisible area if necessary.

The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage/processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.